This is documentation for MapR Version 5.0. You can also refer to MapR documentation for the latest release.

Skip to end of metadata
Go to start of metadata

After you configure the hue.ini, you need to start the Hue Webserver and verify that it has started.

 

Starting and Restarting the Hue Webserver 

  • If Hue is installed on a cluster node (the common use case and recommended practice), run the following command to start the Hue webserver:

  • If Hue is installed on a cluster node (the common use case and recommended practice), run the following command to restart the Hue webserver:

  • If Hue is installed on an edge node (not recommended), run the following command to start the Hue webserver:

Verifying that the Hue Webserver Started

To verify that the Hue webserver started, enter:

 

 

The output from this command should look similar to this:
You can also check Hue webserver logs to verify that Hue webserver started. If the Hue webserver was installed on a cluster node, the log is found here:

If the Hue webserver was installed on an edge node, the log is found here:

  • No labels